- New probe
Hello,
I own a LEO too since 3 weeks, and I follow your site with a great interest.
The first items I have printed are very nice and I was surprised with the very good quality of these
prints.
But, since two day, I’ve got problems with the first layer. It is now impossible to print anything,
because it seems that the PINDA probe does not do his work correctly.
The nozzle touches the Buildtak, the filament does not get out, so the hot end gets clogged.
I saw on your site that you precise to move the jumper to 24V on the main board to reach a better
operation of the probe, I shall test it.
You have changed the probe with another one, bigger, and I have 2 questions about this :
- A friend of mine gave me one with this P/N : LJ12A3-4-Z/BY 4 mm 6-36 VDC 300mA PNP (NO)
but with BX instead of BY, can I use it ? (I don’t know the difference, I’m not very good in electronics)
- If I change the probe, do I have to change something in the firmware or Marlin?
Thank you in advance for your help.
Best regards